SMR Gearbox Set up
Satisfactory performance is dependent upon right installation. lubrication and servicing. therefore it is necessary the instructions in the set up and maintenance leaflet. supplied with every gearbox. are followed carefully. several of the vital facets of belt and torque-arm set up are listed below.
1. Install pulley on gearbox input shaft as near on the reducer achievable, and mount reducer on driven shaft as near to bearing as sensible. failure to carry out this will likely cause extra loads within the input shaft bearings and output bearings and could lead to their premature failure.
2. Install motor and wedge belt drive with the belt pull at somewhere around 90° to your center line in between driven and input shafts. this will likely allow tensioning of the wedge belt drive with the torque arm which really should preferably be in stress. if output hub runs anti-clockwise. torque arm must be positioned the right.
3. lnstall torque-arm fulcrum on a rigid help to ensure that 
the torque-arm are going to be at around suitable angles towards the center line with the driven shaft as well as torque arm situation bolt. make certain there may be adequate take up within the turnbuckle for belt tension adjustment.
Maintain near.
Bell drive can be located in any handy postion. when the torque arm is always to be made use of to tighten the belts, the drive really should be at about tight angle towards the line among the input and output shafts.
Bell drive may be located for the suitable if preferred.
If output hub rotates clock-wise. position belt drive and torque arm in opposite direction to that shown during the illustration.
Torque arm and belt take up.
Torque arm can be mounted to your right if preferred.
SMR Gearbox Installation
Tags: