Electrical power UNITS FOR LIFT TABLE one
Standard Description
This electrical power unit is created solely for your small lift table,Consisting of high pressure gear pump, AC motor, multi-functional manifold, valves, tank, and so on. This electrical power unit continues to be widely utilized from the sector of logistic devices like minifork lift, scissors lift and ariel doing work platforms. The lower-ing movement is controlled from the solenoid valve with the velocity controlled by the adjustable needle valve.
Power UNITS FOR LIFT TABLE 2
Basic Description
This electrical power unit is intended exclusively to the medium lift table, Consisting of hugely effecient gear pump, AC motor, multifunctional manifold, valves, tank, ect. The decreasing movement is actived by the solenoid valve as well as pace managed from the adjustable needle valve. When the lift rises to a substantial positoin, however the power provide is minimize, the lowering movement is managed by the guide override perform.
Power UNITS FOR LIFT TABLE 3
Basic Description
This power unit is created exclusively for your significant lift table, Consisting of very effecient gear pump, AC motor, multi-functional manifold, valves, tank, ect. The decreasing movement is actived through the solenoid valve and also the velocity controlled by a pressure compensated flow manage valve.
Energy UNITS FOR LIFT TABLE four
Standard Description
This power unit is developed exclusively to the significant lift table, Consisting of really effecient gear pump, AC motor, multi-functional manifold, valves, tank, ect. The reducing movement is actived by the solenoid valve and also the pace managed from the adjustable needle valve. When the lift rises to a high positoin, but the power supply is cut, the decreasing motion is controlled from the guide override perform.
Unique Notes
1. This power unit is of S3 duty cycle, which could only perform intermittently and repeatedly, i.e. 1 minute on and 9 minutes off.
two. Clean each of the hydraulic components concerned in advance of installation of the power unit.
3. Viscosity from the oil shoud be 15~46 cst,which must also be clean and free of impurities.N46 hydraulic oil is recommended.
four. Oil transforming is required soon after the original one hundred operation hrs,afterwards as soon as just about every 3000 hours.
5. The power unit shown is built to be mounted vertically.