one.A connecting website link of an O-ring Chain for basic application is pre-coated with grease with the pins. Prior to connection, confirm the grease on the surfaces of pins, and should the quantity of grease is little, apply grease with bare hands. (If gloves are utilised, the grease will be absorbed from the gloves.)
Instance: Once the connecting website link (I) of an O-ring chain for standard application is
shipped, O-rings are fitted at the roots on the pins. In case the O-rings come loose resulting from vibration all through transport, refit the O-rings in to your roots in the pins.
In this instance, be sure to return the grease collected in the roots with the pins on the central surfaces on the pins, more at portion A than at portions B shown within the above illustration. (Portions A is worn due to sliding with the bushings.)
two.The chain can be most quickly linked over the teeth of a sprocket. Engage the hyperlinks at each ends from the chain with all the sprocket teeth and match connecting pins. If your sprocket might be moved, the chain can also be connected about the loosened side.
3. Connecting procedure
one.Verify that O-rings are attached towards the roots of the pins.
two.In the event the volume of grease utilized around the connecting pins is compact, coat the pins with grease in the central portions.
3.Insert the connecting pins into the bushings on the inner links at each ends.
4.Verify the grease is utilized towards the total encounter on the O-ring, and match the O-ring onto the connecting pins.
5.Insert the connecting pins in to the connecting plate and though pressing the connecting plate, set up the spring clip. Verify whether or not the head (the end with no split) with the spring clip is turned inside the feeding course of your chain. (See the following illustration.)
six.Make sure you verify the spring clip is securely fitted while in the clip grooves with the connecting pins.
This completes jointing of the connecting link. Note that grease within the surfaces of connecting pins and O-rings is usually removed throughout set up operate. In this instance, re-grease employing the grease over the surface from the base chain or the grease from the polyethylene bag by which the connecting hyperlink was contained.